In this study, a wireless bio-radar sensor was designed to detect a human heartbeat and respiration signals without direct skin contact. In order to design a wireless bio-radar sensor quantitatively, the signal-to-noise ratio (SNR) in the baseband output of a sensor should be calculated. Therefore, we analyzed the SNR of the wireless bio-radar sensor, considering the signal power attenuation in a human body and all kinds of noise sources. Especially, we measured a residual phase noise of a typical free-running oscillator and used its value for the SNR analysis. Based on these analysis and the measurement results, a compact, low-cost 2.4 GHz direct conversion bio-radar sensor was designed and implemented in a printed circuit board. The demonstrated sensor consists of two printed antennas, a voltage-controlled oscillator, an I/Q demodulator, and analog circuits. The heartbeat and respiration signals acquired from the I/Q channel of the sensor are applied to the digital signal processing circuit using MATLAB. ECG (electrocardiogram), and reference respiration signals are measured simultaneously to evaluate the performance of the sensor. With an output power of 0 dBm and a free running oscillator without a phase locked loop circuits, a detection range of 50 cm was measured. Measurement results show that the heart rate and respiration accuracy was very high. Therefore, we verified that a wireless bio-radar sensor could detect heartbeat and respiration well without contact and our SNR analysis could be an effective tool to design a wireless bio-radar sensor.
|Number of pages||20|
|Journal||Progress In Electromagnetics Research C|
|Publication status||Published - 2008|
Bibliographical notePublisher Copyright:
© 2008, Electromagnetics Academy. All rights reserved.
All Science Journal Classification (ASJC) codes
- Electronic, Optical and Magnetic Materials