Various postsynthesis processes for transition metal dichalcogenides have been attempted to control the layer number and defect concentration, on which electrical and optical properties strongly depend. In this work, we monitored changes in the photoluminescence (PL) of molybdenum disulfide (MoS2) until laser irradiation generated defects on the sample flake and completely etched it away. Higher laser power was required to etch bilayer MoS2 compared to monolayer MoS2. When the laser power was 270 μW with a full width at half-maximum of 1.8 μm on bilayer MoS2, the change in PL intensity over time showed a double maximum during laser irradiation due to a layer-by-layer etching of the flake. When the laser power was increased to 405 μW, however, both layers of bilayer MoS2 were etched all at once, which resulted in a single maximum in the change of PL intensity over time, as in the case of monolayer MoS2. The dependence of the etching pattern for bilayer MoS2 on laser power was also reflected in position changes of both exciton and trion PL peaks. The subtle changes in the PL spectra of MoS2 as a result of laser irradiation found here are discussed in terms of PL quantum efficiency, conversion between trions and excitons, mean interatomic spacing, and the screening of Coulomb interaction.
Bibliographical notePublisher Copyright:
Copyright © 2020 American Chemical Society.
All Science Journal Classification (ASJC) codes
- General Chemistry
- General Chemical Engineering